9/17/2023 0 Comments Scotts standard spreader manual![]() If product lands on any hard surface such as a driveway, sidewalk, or road, sweep the product back onto the lawn to keep it from being washed into the storm sewers and ultimately surface waters.ĥ. When finished, sweep stray particles back onto lawn area. 4ft./sec.), then squeeze and hold trigger (See diagrams below)Ĥ. To apply product, begin walking at a steady pace (approx. Turn orange rate dial to correct setting listed in the Spreader Setting section on the back of each package of Scotts product under "Scotts® Broadcast/Rotary Spreaders"ģ. Fill hopper with Scotts® lawn product of your choiceĢ. Scotts®Turf Builder®EdgeGuard®DLX Broadcast Spreaderġ. ![]() Spreader with EdgeGuard in the off position. ![]() The EdgeGuard Feature blocks off the right side of the spreader pattern to prevent product from spreading onto non-lawn areas.Īutomatically adjusts the flow OFF rate to ensure even application. To activate EdgeGuard feature, slide lever to "On" position Raise the top half of the handle to the upright position and tighten the wing nuts by hand. (set application rate backside of spreader) Sidewalks and waterways - Less waste, less clean-up, less environmental impact Spreader Details: Applies product only where you want it - Keeps product off landscaping, driveways, Scotts®Turf Builder®EdgeGuard® DLX Broadcast Spreader
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |